Tuning tip No1: Right neck (rod) - attitude

Many guitarists don't still know like an optimally put in guitar-neck must look. Admittedly there is to also take individual preferences into account here, (finally, each musician doesn't want a "stamp-string-situation") nevertheless one can comprehend following statements about putting in of the guitar as standard values:

1. Attune guitar on wished pitch

2. With string-rider-screws, provided existing, fingerboard-radius reproduces

3. The deep E-string at the 1. and at the last association down-presses. In the middle of the fingerboard (about). 7. until 10. Association, a clearly visible distance between association-waiter-edge and string-sub-edge must, as well as. Airspace of about. 0,2-0,5 mm is. (One sheet of paper therefore should pass through without problems in any case, the distance small must be loosened the neck-rod. If it should accelerate bigger one it, until the wished neck-curvature "Relief", is reached. Respect: Always only exactly matching tools uses, otherwise the trussrod nut can be damaged!)

4. Put in wished string-action at the bridge. Here a few standard values for string-situations: (It is always judged by the 12 from the association-waiter-edge as far as to the string-sub-edge. Association)

High string-action: E1/E6: 2,5-3,0mm
Normal string-action: E1/E6: 1,8-2,0 mm
Flat string-action: E1/E6: 1,0-1,5 mm

5. Adjust octave pureness

Much success!